Telescoping Fiberglass Flagpole for Flutter Flags

Earn up to 142 Points.

SKU: 359 Category:

Description

Telescoping White Fiberglass Flagpoles

Sizes:  6-15' or 8-21'

Dimensions: Top Diameter 3/4" / Bottom Diameter 1-1/4"

These telescoping fiberglass flagpoles sway in the breeze producing a dramatic, attention-getting display.  PVC ground sleeve included for permanent ground installation.  Reinforced bottom for extra durability.

Additional information

WeightN/A
Flagpole Height (Adjustable)

,

1 review for Telescoping Fiberglass Flagpole for Flutter Flags

  1. Michele

    We live in an area where we have wind constantly, and sometimes very strong wind. Short of getting a $500 commercial pole, I was told this one would hold up - up to 120 mph winds - and ours is usually not over 90 mph.

    We have 3 flags on it, a 3x5 American flag and 2- 2x3 flags, Gadsden and POW/MIA. With the 3 flags it does bend the pole a bit when the wind is blowing, and so we do not have the pole extended to it's full height and this is Spring/Summer - and this time of year the wind is not too bad.

    The instructions say to dig a hold 24-36 inches in diameter, and 2' deep. My hubby followed directions and we had to use 9-80 lb bags of concrete to fill that hole. Well, at least the wind will not blow it out of the ground.

    Anyway, I am a little concerned that a higher wind could snap the pole, and we may have to remove one of the flags if the wind gets too strong, but if the pole does not snap, I'll revise my rating to 5 stars.

Only logged in customers who have purchased this product may leave a review.

Earn
Rewards
Welcome back!

Crop Image

envelopephone-handsetcrossquestion-circlemenu-circle linkedin facebook pinterest youtube rss twitter instagram facebook-blank rss-blank linkedin-blank pinterest youtube twitter instagram